Gyraf G10

The Gyraf Audio Gyratec X G10 is a true tube stereo compressor based on the classic variable-mu principle. This method - controlling the gain by altering quiescent current in differential tube pairs - is much faster than the optical method. The speed is why it was widely used in early limiter devices such as the Fairchild 670 or the Universal Audio 176, but the sonic byproducts of this topology are the main reasons why it is so popular today.

The controls on the G10 are as follows:

• The input level pot is positioned right after the input transformers, thus allowing you to control the input level, the "drive" for the compressor.
• The Threshold pot controls at what level the compression will set in. Turning counter-clockwise will select a lower start point, resulting in more compression. When turned fully clockwise, the compression is deactivated.
• The Ratio pot controls the amount of compression in relation to changes in the input level, that is, for the part of the signal that exceeds the threshold value that is set. Setting the Ratio fully counter-clockwise will deactivate compression.
• The Attack pot controls the time the compressor takes to react to a rising input level.
• The Release pot controls the amount of time it takes from the input signal falling below the threshold, to the gain reduction being returned to unity.
• The Output level pot controls the signal level to the output driver stage and the output.
• The Bypass switch bypasses the unit completely. The hard way. - A relay simply takes out the active electronics and shorts the input to the output connectors.

The G10 is floating, transformer balanced in and out. Input impedance > 10K Ohm, output impedance < 1K Ohm.

It is based on a very short true-differential signal path from input to output, using very, very tightly selected PCC189 (7ES8) remote-cutoff dual triodes for the VCA stages, and E88CC (6DJ8) low-noise triodes as cathode followers for the output stage drivers. Both tubes are still fairly easily available throughout the world.

Although semiconductors and opamps are used in this unit, they're confined to power supply and sidechain functions. At no time will your audio pass through anything but transformers, tubes and passives. So we're talking REAL tube audio here.

This item, like everything we supply, comes with the complete support of our expert team. Our excellent technicians have been specifying, building and supporting studios for over twenty years. If you have any problems with installation, setup or everyday use, they’re never more than a click away, and always happy to help.

You can contact them here.