+44 20 8445 2446
Superior Acoustic Authenticity
The DPA ST2006A uses Twin Diaphragm Capsule technology, offering a well-balanced sound that captures true character and authentic acoustics, ideal for high-fidelity recording.
The DPA ST2006A Stereo Pair Twin Diaphragm Omni Microphone is part of the Reference Standard Series and is built around the acclaimed DPA 4006 omni microphone, due to its sound character and industrial design. The ST2006A is great for miking and recording orchestra, acoustic piano, guitar, wind instruments, vocals and choirs. Complete with Peli transportation case, holders, and windscreens.
The ST2006A from DPA features a Twin Diaphragm Capsule technology. This makes the ST2006A well balanced for acoustic authenticity and true character. The capsules are loaded to the supreme Reference Standard preamps instead of the tiny miniature FET preamp from the miniature mics, offering, even more, air and precision.
In a 2006 capsule two opposite-facing miniature capsules are custom re-built into a double diaphragm, one-capsule composition. This combines the advantages of small capsules (fast impulse response and large frequency bandwidth) with lower inherent noise achieved from a larger diaphragm area.
Specifactions:
- Stereo Pair
- Directional pattern: Omnidirectional
- Principle of operation: Pressure
- Cartridge type: Pre-polarized condenser, Twin Diaphragm Capsule
- Frequency range: 20 Hz to 20 kHz
- Frequency range, ± 2 dB: 50 Hz to 20 kHz with typ. 3 dB soft boost at 14 kHz
- Sensitivity, nominal, ± 2 dB at 1 kHz: 40 mV/Pa; -28 dB re. 1 V/Pa
- Equivalent noise level, A-weighted: Typ. 16 dB(A) re. 20 µPa (max. 18 dB(A))
- Equivalent noise level, ITU-R BS.468-4: Typ. 28 dB (max. 30 dB)
- S/N ratio (A-weighted), re. 1 kHz at 1 Pa (94 dB SPL): Typ. 78 dB(A)
- Total Harmonic Distortion (THD) at 1 kHz: < 1 % up to 130 dB SPL peak
- Minimum load impedance: 2 kohm
- Dynamic range: Typ. 114 dB
- Max. SPL, peak before clipping: 141 dB
- Switchable attenuator: 0 dB / -20 dB
- Output impedance: < 200 ohm
- Cable drive capability: 100 m (328 ft)
- Output balance principle: Impedance balancing with Active Drive
- Common Mode Rejection Ratio (CMRR): > 60 dB
- Power supply (for full specification
- Current consumption: 2.8 mA
- Connector: XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase
- Colour: Matte black
- Microphone weight: 160 g (5.6 oz)
- Microphone diameter: 19 mm (0.75 in)
- Microphone length: 164 mm (6.5 in)
- Output voltage, RMS: > 5 V
- Polarity: +V at Pin 2 for positive sound pressure
- Temperature range: -40 °C to 45 °C (-40 °F to 113 °F)
- Relative Humidity (RH): Up to 90%
- UK over £99 FREE
- UK under £99 £10
- EU £36
- Rest of World £80
Large/Heavy items: Extra charges may apply (e.g., consoles, large monitors). We’ll contact you before processing if so.
We ship with DPD and UPS across the UK, EU and worldwide. Same-day within the M25 is available depending on stock from £48.
At KMR, we provide exceptional support for all your audio studio requirements. Our committed team is ready to help you with setup, troubleshooting, and optimizing your gear for peak performance.
If you face any challenges, our customer service team is just a phone call away, prepared to offer expert assistance.
KEY FEATURES
Enhanced Noise Reduction
Featuring a double diaphragm, one-capsule composition that integrates the benefits of small capsules with a larger diaphragm area, the microphone significantly lowers inherent noise, ensuring clearer audio capture.
Extended Dynamic Range
With a dynamic range of approximately 114 dB and the ability to handle up to 141 dB SPL peak, the ST2006A provides flexibility in capturing a wide range of volumes without distortion, suitable for various professional recording needs.